10. [ ] Assembly instruction: J3 needs to be loaded and jumper inserted
-<<<<<<< .mine
-11. [ ] Microphone pins are swapped, ie rotate by 180 degrees.
-=======
11. [ ] Microphone pins are swapped, ie rotate by 180 degrees.
->>>>>>> .r1992
-<<<<<<< .mine
-12. [ ] Should R46 be log?
-=======
12. [ ] Should R46 be log? Last half of travel makes very little difference to subjective volume.
->>>>>>> .r1992
-<<<<<<< .mine
13. [ ] With bud type headphones, a low volume leve is reqd. At these
levels some low freq noises at the frame rate and HF hiss can be
heard. As these noises are still heard with zero volume its
loudspeaker fine. Amount of noise varies with headphones used. As
volume is hard to regulate perhaps another option si a series
resistor with the headphone jack.
-=======
-13. [ ] With bud type headphones, a low volume leve is reqd. At these
- levels some low freq noises at the frame rate and HF hiss can be
- heard. As these noises are still heard with zero volume its
- probably noise from U8. Might need soem HP/LP filtering. Thru
- loudspeaker fine. Amount of noise varies with headphones used. As
- volume is hard to regulate perhaps another option si a series
- resistor with the headphone jack.
->>>>>>> .r1992
14. [ ] Decide if power supply and USB programming cable should be included in BOM.
15. [ ] Artwork (i.e. a coloured sleeve) for the box? Price? Who can design artwork?
+16. [ ] Change C33 from 100nF to 220nF, to bring HPF corner frequency down.
+
+17. [ ] Change Mic1 to Digikey part rather than generic subsitute
+ + Generic part resulted in "tinny" audio
+ + Digikey part fixed audio, sounded similar to Yaseu MH31
+
+18. [ ] Confirm on/off power switch parts used is loose sample Edwin packed with the Qty 2 prototypes.
+
+19. [ ] Choose and order new PTT switch