\r
-Change Log for SM1000-REV-B2\r
+Change Log for SM1000-REV-C\r
\r
Changes 07/22/2014 Reformatted file to fit on Schematic.\r
Reformatted file to include Status: and status indicator. RGB 09/15/14\r
\r
42. [X] added 3.9nF between U8 p3 and ground \r
+ removed some tonal noise and \r
- Status: No action taken - What is 3n9? Will add.\r
+ Status: Added. RGB 09/26/14\r
\r
43. [X] changed R39 to 2k2\r
+ mic bias now 2.8V\r
- Status: No Action Taken, Same as #25 RGB 09/10/14\r
+ Status: Changed. RGB 09/26/14\r
\r
-44. [O] Switcher noise reduction idea\r
+44. [X] Switcher noise reduction idea\r
+ is there away to lock the switcher osc to a uC clock?\r
+ we could make it a multiple of ADC/DAC sample rate\r
+ thus aliasing all noise down to 0 Hz\r
+ need swicther to freerun until uC starts\r
From data sheet, switcher freq determined by components. No ext sync capability. RGB 09/10/14\r
For intermittent starts, look at ext PS rise ti me?\r
+ Status: Suggested shielded inductor. RGB 09/26/14\r
\r
45. [O] review jumpers and see if it makes mores sense to make them 0 ohm 0805s\r
If you implement self test code, then you want J1, but don't ship shunt.\r
J3 - there to remove bias from mic input. Need?\r
Status: need decision from David. RGB 09/10/14\r
\r
-46. [O] C24 closer to U1?\r
+46. [X] C24 closer to U1?\r
WIll move at re-route time. \r
Status: WIll move in PCB re-layout. RGB 09/10/14\r
\r
\r
48. [X] LD2 opto-isolator footprint wrong (or maybe I ordered wrong part) \r
My mistake. Part is 8mm pin to pin, not 6mm.\r
- Status: Will correct footprint & PCB RGB 9/10/14\r
+ Status: Corrected. RGB 09/26/14\r
\r
49. [X] location of C51 net label\r
DOne. \r
\r
2/ L1, R10, C10, C12, C11, C13 close to U1 with direct connection to p20\r
\r
+<<<<<<< .mine\r
+3/ Large labls for connectors and trimmers. Maybe single letters or\r
+symbols so they can fit? So user doesn't have to refer to schematic\r
+=======\r
3/ Large labels on PCB for connectors and trimmers. Maybe single letters or\r
symbols so they can fit? So user doesn't have to refer to schematic\r
+>>>>>>> .r1859\r
when setting up.\r
\r
4/ "As per June 2001 pcd mixed signal ... " PDF\r