Corrected package for LED-LTST - LED5 & LED8.\r
07/09/2014 - RGB\r
\r
-4. [ ] Is CN3 a standard size? My DC plugs don't fit in it \r
+4. [X] Is CN3 a standard size? My DC plugs don't fit in it \r
2.5mm ID, 5.5mm OD Plug. CONN PWR PLUG DC 2.5X5.5 8A MOD Digikey # \r
CP3-002BH-ND \r
- This is probably most common size in USA. Change? \r
+ This is probably most common size in USA. Same size as Raspberry PI, BeagleBone , SignaLink & others. RGB 07/15/2014\r
\r
-5. [ ] couldn't solder bottom pad of U5 by hand + hope it's OK \r
+5. [X] couldn't solder bottom pad of U5 by hand + hope it's OK \r
Attached to large gnd plane. Hard to solder. Designed for IR SMT \r
assembly. Try large iron on vias from bottom. \r
+ Part will solder in production. RGB 07/15/2014\r
\r
6. [ ] Can R6,R2,R5,R3,R4 be 10k to match R1? \r
Don't know if 10K will work for R6. Discovery has 680 or small value. \r
CN3 is Switchcraft RASM712PX 2.5mm ID, 5.5mm OD Plug. CONN PWR PLUG DC 2.5X5.5 8A MOD Digikey # CP3-002BH-ND\r
I've noted a problem, but will wait til you decide. RGB\r
\r
-14. [ ] OK I just check the BOM I have, and there are no 4.7k resistors on it, e.g. R2, R3, R4, R5. Oh OK, the BOM has a part number. Not sure what that mapped to on my Digikey order, just noticed I didn't get any 4k7s. Maybe change the BOM to indicate the part value? \r
- Part database error, invalid part definition. Digikey & Vishay Dale part numbers are correct. Part definition for R2, R3, R4, R5 & R48 should be: RES 4.70K OHM 1/10W 1% 0603 SMD Will correct part database & BOM.\r
+14. [X] OK I just check the BOM I have, and there are no 4.7k resistors on it, e.g. R2, R3, R4, R5. \r
+ Part database error, invalid part definition. Digikey & Vishay Dale part numbers are correct. \r
+ Part definition for R2, R3, R4, R5 & R48 should be: RES 4.70K OHM 1/10W 1% 0603 SMD Will correct part database & BOM.\r
+ R2, R3, R4, R5 & R48 now 4.70K 1/10W 1% 0603 parts in B2 revision. RGB 07/15/2014\r
\r
15. [X] CN7 3.5mm socket etc have two small plastic mounting lugs that require holes\r
CN7, CN8, CN9 & CN10 plastic tabs interfere with pads on top layer. Since the tabs are plastic and don't extend thru the PCB, I am approving these 4 discrepancies. RGB 07/15.2014 \r